Here – Edimax Technology WP-S1000 User Manual

Page 47

6.2 Reset The Projector Server To Factory Default Setting

In some cases, you may lose the control of your projector server, eg: you forget the

administration password, or you can’t get access to the administration interface for some

reasons. You can use reset button located at the back of the projector server, to clear all

settings (include admin password).

Please follow the following instructions to perform the reset:

1. Press ‘PWR’ button to make sure the projector server is switched off.

2. Use a pen or pin to press ‘RESET’ button located at the back of projector server and hold

still.

3. Press ‘PWR’ button to switch projector server on (you should still press and hold ‘RESET’

button now).

4. Release ‘RESET’ button after 10 seconds, and the projector server will be restored to

factory default settings, you may use default password to access administration menu

now.

HERE