Edimax Technology WP-S1000 User Manual

Page 46

also use a pen or pin to press the ‘RESET’ button located at the

back of projector server.

6. Ask your network administrator or a qualified technician for help.

The image

displayed on

projector or CRT /

LCD monitor is

distorted

1. Make sure the video cable is securely connected to ‘VGA’ jack at

the back of the projector server. You may also check the video

connection to the projector or CRT/LCD monitor.

2. Make sure the projector or CRT/LCD monitor works with the video

output setting of projector server. You can change to a lower

resolution and see if the display on projector or CRT/LCD monitor

becomes normal (see Chapter 5.7 for detailed instructions for

changing the output resolution).

3. Replace the video cable used to connect the projector server and

your projector or CRT/LCD monitor with a new one.

4. Contact your projector or CRT/LCD monitor manufacturer for help.

The wireless

signal reception is

bad

1. If you’re using this projector server in an extremely big room, you

may wish to try another antenna with high signal gain for better

signal reception. Contact your dealer of purchase for detailed

information. DO NOT ATTEMPT TO REAPLCE THE ANTENNA

BY YOURSELF IF YOU’RE NOT SURE WHAT ANTENNA YOU

SHOULD USE!

2. Move your computer closer to the projector server if possible, or

use wired connection.

3. The wireless antenna on the projector server should be

perpendicular to the ground for better reception.

Cannot connect

wirelessly to the

projector server

1. If you set the projector server to use wireless encryption, all

wireless clients should input the correct WEP key before they can

get connected.

2. Make sure the SSID of the projector server is found by your

computer, and you connect to the correct SSID for the projector

server.

3. Reboot your computer and try again.

No audio

1. Check the volume setting of your computer and your audio

speaker / amplifier.

2. Check the audio cable that connects the projector server and your

audio speaker / amplifier.

3. Replace the audio cable with a new one.