Dimplex DXW 330 - Manual (Page 3)

357
MIN 230
450 MIN
577 230
MIN 230
MIN
Instructions for Installation and Use
DXW 307 – DXW 330 Convector Heater
07/10/D
1. Important Information
Please read carefully all the information provided in these
instructions. Keep the instructions in a safe place and if
necessary give them to any future owner.
- The device may only be installed by an authorized and
qualified technician.
- The unit may only be used for space heating in en-
closed rooms.
- Any examination of the heater or repair work may only
be carried out by a qualified electrician.
- Disconnect the heater from the power supply if it is
faulty or is not used for a long time. Disconnect or un-
screw fuse.
- Do not cover the heater in any way (risk of fire).
- Warning: Outer surfaces become hot when heater is
switched on.
- Do not leave heater unattended when small children
are present.
- Do not insert any objects into the openings.
- Do not use the heater in rooms containing flammable
materials (e.g. solvents, etc.).
- Do not place the connecting lead on top of the appli-
ance.
- Warning: If the heater is switched on automatically (by
the thermostat), there is a danger of fire if it has been
in any way covered or blocked.
2. Positioning, Installation, Minimum Clearances
When installed, the heater must be aligned horizontally on a
vertical wall, as shown in the illustration.
The minimum clearances shown below must be complied
with.
In addition, a minimum distance of at least 500 mm must be
maintained in front of the heater.
The heater must not be located directly beneath a wall
socket outlet.
Do not install the heater where the controls can be reached
by a person bathing or showering.
Caution: Do not place near flammable objects.
Ensure that air can enter and leave the heater freely, at the
inlets below and the outlets above.
Wall Mounting
IMPORTANT-
The original wall brackets supplied attached to the rear of
the unit must be used.
- Drill mounting holes for the wall brackets.
- Screw the brackets securely to the wall.
- Hang the heater from the wall brackets using the slits in
its rear wall.
- Secure the heater at the top on the wall brackets.
3. Electrical Connection
The heater lead must be connected to a suitable socket.
If the connecting lead is damaged, it must be replaced; a
special new lead can be obtained from the manufacturer or
from after-sales service.
4. Heater Operation
All switch functions are explained below.
On/Off
Output 50%, 100%
(DXW 315 – DXW 330)
Thermostat
The heater is equipped with a thermostat, by means of
which the desired room temperature can be set.
The setting * represents a room temperature of about 6°C
(protection against freezing).
Turning the thermostat knob to the right (clockwise) in-
creases the temperature setting, while turning to the left
(anticlockwise) reduces the desired temperature.
I
II
O
I
GB
3