Dremel VersaFlame - Manual (Page 4)

4
ORIGINAL INSTRUCTIONS
Before using the Dremel VersaFlame, make sure you read and
understand this manual completely.
! WARNING
READ ALL INSTRUCTIONS.
Failure to follow all instructions listed below may result in fire
and/or serious injury.
SAVE THESE INSTRUCTIONS
1. WORK AREA
a. Keep work area clean and well lit. Cluttered and dark areas
invite accidents.
b. Do not keep combustible materials near the tool.
c. Keep children and bystanders away while operating the tool.
Distractions can cause you to lose control.
d. Only use the tool outdoors or in well-ventilated rooms.
2. PERSONAL SAFETY
a. Stay alert, watch what you are doing and use common
sense when operating the tool. Do not use the tool while
you are tired or under the influence of drugs, alcohol or
medication. A moment of inattention while operating tools
may result in serious personal injury.
b. Use safety equipment. Always wear eye
protection. Safety equipment such as a dust
mask, non-slip safety shoes, hard hat and hearing
protection used for relevant conditions will reduce
personal injuries.
c. Do not overreach. Keep proper footing and balance at all
times. This enables better control of the power tool in
unexpected situations.
d. Dress properly. There is a danger of burning yourself with
the flame or with liquid soldering tin. Wear protective
clothing to protect yourself against burns. Keep your hair,
clothing and gloves away from the flame. Loose clothes or
long hair can catch fire.
e. Secure the workpiece. Use a clamping device to hold the
workpiece. This allows you to use both hands to operate the
tool.
f. Keep this manual for future reference.
g. Do not use the appliance when it is leaking (gas smell),
shows any sign of damage or is malfunctioning.
h. If the appliance is leaking (gas smell) immediately take
it outside and check the leak-tightness without a flame.
Always use soapsuds. (Re)filling the gas tank must be
done in a well-ventilated place far away from any possible
sources of ignition, open flames, pilot lights, electrical
cookware and away from other persons. Be sure to observe
the safety instructions and warning notices on the refill
container. Do not make any modifications to the tool.
i. Do not work materials containing asbestos (asbestos is
considered carcinogenic).
j. Take protective measures when during work dust can
develop that is harmful to one's health, combustible or
explosive (some dusts are considered carcinogenic); wear
a dust mask and work with dust/ chip extraction when
connectable.
3. TOOL USE AND CARE
a. Store your tool in an appropriate place with an ambient
temperature between 10°C and 50°C. Allow your tool to fully
cool down before storing. Unused tools should be stored away
from children in a dry location. Switch off all unused tools.
b.
! WARNING
Always switch off the tool and allow it
to fully cool down before attaching or
removing the accessories or before cleaning.
c.
! WARNING
Extremely flammable gas under
pressure.
d.
! WARNING
Do not use near sparks or an open
flame.
e.
! WARNING
Do not puncture or incinerate the gas
tank or store at a temperature above
50ºC.
f.
! WARNING
Keep out of reach of children.
g.
! WARNING
Do not try to disassemble this unit.
4. SERVICE
a. Have your tool serviced by a qualified repair expert using
only identical replacement parts. This will ensure that the
safety of the power tool is maintained.
ENVIRONMENT
DISPOSAL
The tool, accessories and packaging should be sorted for
environment-friendly recycling.
SPECIFICATIONS
GENERAL SPECIFICATIONS
Description . . . . . . . . . . . . . . Dremel VersaFlame
Model number . . . . . . . . . . . 2200
Power source . . . . . . . . . . . . Refined butane gas
Gas tank capacity . . . . . . . . 42 ml / 22 grams
Run time . . . . . . . . . . . . . . . ± 75 minutes (highest setting)
Heat-up time . . . . . . . . . . . . ± 25 seconds (soldering tip)
Nominal heat input . . . . . . . 16 g/h
Cool-down time . . . . . . . . . . 17 min (< 25°C)
Temperature . . . . . . . . . . . . 1200°C (open flame)
680 – 1000°C (hot air)
550°C (soldering tip)
Weight . . . . . . . . . . . . . . . . . 227 grams (empty tool)
GB