3M S10C - Manual (Page 4)

Part Names
The Projector
Indicates the corresponding
reference page
Attaching The Base
Focus ring
Air filter cover
(An air filter is
inside.)
Elevator button
Elevator feet
Lens
(The picture is
projected from here.))
Projector (Front/Right)
Remote sensor
Zoom knob
1
Turn off the projector, and unplug the power cord. Allow the lamp
bulb to cool for at least 45 minutes.
After making sure that the projector
has cooled adequately, slowly flip
over the projector, so that the bottom
is facing up.
2
Put the base on the bottom of the
projector, as shown in the fugure.
Then slide it to the back of the projector
until it locks into position.
3
Slowly turn the projector so that the top is facing up.
To remove it, slide the base to the front
of the projector pinching the lever
of the base.
4
4
CAUTION • Be careful not to pinch your finger on the occasion of the handling of a base.
Do not hold the base, lens or other project part to move the projector.
• Do not use the base to suspend the projector.
• Do not push or put anything on the both sides of the top of the projector.