3M X50C - Manual (Page 7)

6
Adjusting the Projector's Elevator Foot
1
Press and hold in the elevator
button
2
Raise or lower the projector to the
desired height and then release the
elevator button
When you release the elevator button, the elevator
foot will lock into position.
3
As necessary, you can also finely
adjust the left-right slope of the
projector by twisting the rear foot
You can use the elevator f
oot to make adjustments if the surface on which you
need to set the projector is uneven or if you otherwise need to adjust the angle of
projection. The adjustment range of the elevator f
oot is 0 to 9 degrees.
CAUTION • Install the projector in a suitable environment according to instructions
of the "Product Safety Guide" and this "Operator's Guide".
• If you press the elevator button without holding the projector, the projector might
crash down, overturn, smash your fingers and possibly result in malfunction. To
prevent damaging the projector and injuring yourself, ALWAYS HOLD THE
PROJECTOR whenever using the elevator button to adjust the elevator foot.
SETTING UP THE PROJECTOR
9
Rear Foot Adjuster
adjuster screw by hand