3M X50C - Manual (Page 17)

16
1
Press the STANDBY/ON button of the remote
control or on/off button of the control panel
The message "Power off?" will appear on the screen for approximately 5 seconds.
3
TURNING OFF THE POWER
VIDEO
ASPECT
HOME
END MUTE PAGE DOWN
KEYSTONE FREEZE
OFF
ON
MENU POSITION
ENTER
ESC RESET
PAGE UP VOLUME MAGNIFY
AUTO BLANK
RGB SEARCH
STANDBY/ON
lamp
temp
power
on off
video rgb
reset
menu
keystone
Control panel
2
Press the STANDBY/ON button or the on/off
button again
Press the STANDBY/ON button or on/off button again while the
"Power off?" message is visible. The projector lamp goes off and
starts cooling down. The power indicator blinks orange while the
lamp cools down. (Pressing the STANDBY/ON button while the
power indicator is blinking orange has no effect.)
The system goes into the STANDBY mode after cooling
down and the power indicator stops blinking orange and
then lights to solid orange.
Check that the power indicator stops
blinking and lights to solid orange.
When the projector has
Switch the power switch to [O] (OFF).
completed powering down,
the power indicator will go off.
power switch
POWER indicator
• Except in
emergencies, follow
the above-
mentioned
procedure for
turning power off.
NOTE