3M MP8750 - Manual (Page 17)

12 3M

Multimedia Projector MP8750

3M 1999
Section 5: Remote Control
5-1. Remote Control Functions
Aim the remote control toward the projection screen or at the sensor. Press desired remote button to send a signal to the
projector.
*Standby: Switch the projector
between Standby mode (lamp off,
fan off) and operation mode (lamp
on, fan on).
*Zoom: Increase (+) or decrease
(-) size of displayed image.
*Menu: Display system menus.
*PC: Switch to PC mode. In PC mode,
toggles between RGB 1 and 2.
*Focus: Adjust focus (+/-) of
displayed image.
*Video: Switch displayed image to
video input.
*Bright: Increase (+) or decrease (-)
brightness of displayed image.
*Enter: Mouse emulation ON, left
mouse button. Mouse emulation Off,
Enter button for confirmation of a
selection.
*Mute: Toggle ON/OFF the audio sound.
*Volume: Increase (+) or decrease (–)
speaker volume.
Disc Pad (mouse pointer): Move
(point) the cursor on the projected
image. Navigate menus. See Pointer.
Window: Toggle between full
screen and centered display mode
(non-AGA modes only)
Mode 1,2,3,4: Toggle between remote control
addresses 1, 2, 3, 4.
Drag: Lock left mouse button.
Optimize: Adjust brightness and
contrast for best picture.
Reveal: Press Reveal to cover the image on
the screen with a gray mask. Use the Disc
Pad to reveal the image. Press Reveal again
to return full screen projection of image.
Text: Not used.
Blank: Replace projected image with
white background. Press again to
return image.
Timer: Displays timer (window in lower
part of screen). Repeated operation of
key toggles on/off.
Mouse: Toggle mouse emulation on/off.
ON: The L & R buttons operate left & right
mouse key functions. Drag-an-drop
functions are possible by pressing the Drag
button.
OFF: L button is the Enter confirmation
b tt
R b tt t d Di P d t
Freeze: Stores (freezes) the projected
image. Press again to return the
projection of the current image.
Magnify: Press to enable magnification
mode. Press +/- buttons to
increase/decrease the magnification
factor. Move Disc Pad to displace the
magnified area within the image. Press
Magnify again to toggle back to normal
presentation.
In video mode (NTSC only), press
Magnify to toggle between scaled and
unscaled representation.
Pointer: Place a pointing device on the
screen. Use Disc Pad to move pointer.
Info: Display information window.
P
Aux: Toggle ON/OFF a 3M
compatible device.
An icon will display to indicate a presentation tool is
active.
Pointer Freeze Mouse Mute On Magnify Reveal
Image Image Image
ь ь Note
The buttons marked with an asterisk (*) also appear on the
operator touch panel keyboard.