3M MP8750 - Manual (Page 16)


3M 1999 3M

Multimedia Projector MP8750 11
4-5. Menu Adjustments/Settings, continued
Advanced Setup
(PC/RGB)
Submenu Items
Description / Action Default
Setting
Projection (drop down
window) Select projection orientation
(standard / Rear / Rear/Ceiling /
Ceiling) standard
Remote Control Remote control receiver -on / -off -on
RC Address Select remote control address
(1 / 2 / 3 / 4) 1
Sync Mode1
(drop down window) Select Sync Mode for PC/RGB1
(separate TTL / composite TTL /
separate ana. / composite ana. /
sync on green) separate TTL
Sync Mode2
(drop down window) Select Sync Mode for PC/RGB2
(separate TTL / composite TTL /
separate ana. / composite ana. /
sync on green) separate TTL
SOG Level Adjust level for sync on green
synchronization
Reset Data Modes Set all data modes to factory default
settings.
Reset lamp display Resets the lamp hours displayed on
the Info window
Test Display test submenu
Advanced Setup
(Video)
Submenu Items
Description / Action Default
Setting
Projection
(drop down window) Select projection orientation
(standard / Rear / Rear/Ceiling /
Ceiling) standard
Remote Control Remote control receiver -on / -off -on
RC Address Select remote control address
(1 / 2 / 3 / 4) 1
Video standard
(drop down window) Select Video standard
(PAL B,G,H,I / NTSC M / SECAM /
NTSC 44 / PAL M / PAL N / PAL 60 /
NTSC COMB / automatic) automatic
Reset lamp display Resets the lamp hours displayed on
the info window
Test Display test submenu
Test
Submenu Items
Description / Action Default
Setting
Parameter display Parameter display window
-on / -off
-off
Color test picture Display color test picture
Frame test picture Display frame test picture
Info (display only) Description / Action
Hardware Current hardware level
Firmware Current firmware level
VESA xxxxxxxxxx Current video mode
Lamp (bar indicator) Lamp life hours (Green: lamp good /
red: lamp needs replacement)
OK! Closes the Info display by pressing
the Enter button
Advanced Setup
Projection standard
Remote Control
RC Address 1
Sync Mode1
separate TTL
Sync Mode2 separate TTL
SOG level
Reset Data Modes
Reset lamp display
T t
Test
Parameter display
Color test picture
Frame test picture
Advanced Setup
Projection standard
Remote Control
RC Address 1
Video standard automatic
Reset lamp display
Test
3M
MP8750
Hardware: xxx-x.xx-x
Firmware: xxx-x.xx
VESA 1024 x 768 75 Hz
Lamp
OK!