Yamaha RX-V596RDS - Manual (Page 27)

25
English
B
ASIC OPERA
TION
AD
V
ANCED OPERA
TION
APPENDIX
INTR
ODUCTION
PREP
ARA
TION
■ On the remote control
1 Make sure that the effect speakers (center and
rear) and subwoofer are turned on.
2 Press DSP.
The indicator lights up for about
three seconds.
3 Use the numeric buttons
(1 to 8) to select the
desired program before the
indicator goes off.
The name of the selected
program appears on the display.
If the selector dial is set to the DSP/TUN position, you
can select a DSP program directly with the numeric
buttons.
y
If desired, adjust the delay time and the sound output level of each
speaker. (Refer to pages 42 and 43 for details.)
Notes
• You can select a DSP program for each of the input sources. Once
you select a program, it is linked with the input source selected at
that time. So, when you select the input source next time, the
same program is automatically selected.
• When a monaural source is being played with PRO LOGIC/
Normal or PRO LOGIC/ENHANCED, no sound will be heard
from the main speakers and the rear speakers. Sound can only be
heard from the center speaker. However, if “CENTER SP” on the
SET MENU is set to the NONE position, the center channel
sound is output from the main speakers.
• When a source connected to the EXTERNAL DECODER INPUT
terminals of this unit is selected, the digital sound field processor
cannot be used.
• When high-rate 96-kHz sampling 24-bit digital signals are input
to this unit, no DSP program can be selected and the sound is only
output from right and left main speakers as a normal 2-channel
stereo sound.
DIGITAL SOUND FIELD PROCESSOR (DSP) EFFECT
Selecting a DSP Program
You can enhance your listening experience by selecting a
DSP program. Refer to pages 35 to 37 for details about each
program.
■ On the front panel
1 Make sure that the effect speakers (center and
rear) and subwoofer are turned on.
2 Press PROGRAM h or l
repeatedly to select the
desired program.
The name of the selected
program appears on the display.
L R – + – +
2
2
3
DSP program name
DSP program name
0104V596RDS21-26_EN 2/29/0, 3:29 PM 25