beautypg.com

18 impedance selector switch, Connecting the power supply cords, Ac outlets (switched) – Yamaha RX-V596RDS User Manual

Page 20

background image

18

IMPEDANCE SELECTOR Switch

WARNING

Do not change the IMPEDANCE SELECTOR switch setting while the power of this unit is on, otherwise the unit may be
damaged.
If this unit fails to turn on when STANDBY/ON (or POWER) is pressed, the IMPEDANCE SELECTOR switch may not
be fully slide to either position. If so, slide the switch to either position fully when this unit is in the standby mode.

Select the right or left position according to the impedance of speakers in your system. Be sure to move this switch only
when this unit is in the standby mode.

Connecting the Power Supply Cords

After completing all connections, connect the AC power
cord to an AC power outlet. Disconnect the AC power cord
if you will not use this unit for a long period of time.

AC OUTLETS (SWITCHED)

Europe model .................................................... 2 OUTLETS
U.K. model .......................................................... 1 OUTLET
Use these outlets to connect the power cords from your
components to this unit. The power to the AC OUTLET(S)
is controlled by this unit’s STANDBY/ON (or POWER and
STANDBY). These outlets will supply power to any
connected component whenever this unit is turned on. The
maximum power (total power consumption of components)
that can be connected to the AC OUTLET(S) is 100 W.

If you use

left position

right position

CONNECTIONS

(Europe model)

SWITCHED

(Europe model)

To AC outlet

IMPEDANCE

SELECTOR

Rear speakers The impedance of each

speaker must be 6

or

higher.

The impedance of each

speaker must be 8

or

higher.

Center

speaker

The impedance must be 6

or higher.

The impedance must be 8

or higher.

If you use one pair of main

speakers, the impedance of

each speaker must be 4

or

higher.

If you use one pair of main

speakers, the impedance of

each speaker must be 8

or

higher.

If you use two pairs of main

speakers, the impedance of

each speaker must be 8

or

higher.

If you use two pairs of main

speakers, the impedance of

each speaker must be 16

or

higher.

Main

speakers

0103V596RDS09-20_EN

2/29/0, 3:29 PM

18