Viewing your product’s certifications – ZyXEL Communications ADSL2+ Ethernet / USB Router P-660RU-Tx v2 User Manual
Page 22
21
P-660RU-Tx v2 Quick Start Guide
• Click the wizard icon (
). Run the Internet Setup
wizard again. Check whether you can access the Inter-
net.
If you still cannot access the Internet, take the following
steps:
• If you are using Bridge mode (check Mode in the Net-
work > WAN > Internet Connection screen) click NAT
> General and ensure Active Network Address Trans-
lation (NAT) is not selected. Click LAN > DHCP Setup
and ensure that DHCP is set to None. Your ISP gives
your computer an IP address directly. If you want to
access the P-660RU-Tx v2 again, you need to use a
static IP address in the same subnet as your P-660RU-
Tx v2 (the P-660RU-Tx v2’s default IP address is
192.168.1.1).
• Click the wizard icon (
). Run the Internet Setup
wizard again. Check whether you can access the Inter-
net.
If you still cannot access the Internet, contact your Internet
Service Provider.
Viewing Your Product’s Certifications
1 Go to
2 Select your product from the drop-down list box on the
ZyXEL home page to go to that product's page.
3 Select the certification you wish to view from this page.