Yamaha DME24N - Manual (Page 39)

P
anel Operation and Displa
ys
Parameter Edit Displays
DME64N/DME24N Owner’s Manual 39
Mute Switching
Turns the DME64N/24N output mute function ON or
OFF.
1.
Press the [MUTE] key.
The Mute Parameter Edit display will appear.
2.
Select Mute ON or OFF.
The mute function is turned on or off as described in
“ON/OFF Parameters” on page 38.
Output Level Control
Adjust the output level of the DME64N/24N.
1.
Press the [LEVEL] key.
The “Output Level” Parameter Edit display will appear.
2.
Adjust the numeric output level parameter as
required.
The Output Level parameter is adjusted as described in
“Numeric Parameters” on page 36. The graphic fader
provides a visual indication of the current output level
setting.
Scene Recall
This procedure recalls a new scene (refer to page 10).
1.
Press the [SCENE] key.
The Scene Recall display will appear.
2.
Select a new scene.
Scenes are selected as described in the “List Parameters”
section on page 38.
3.
Press the [ENTER] key.
A confirmation window will appear.
4.
Press the [ENTER] key again.
The new scene will be selected.
Don’t turn the power off during a scene recall
operation. Doing so can cause corruption of the
current scene data.
NOTE
To access this function from the ICP1 control panel, hold the
[F6] key for longer than 2 seconds.
NOTE
All outputs in the device group, including the [PHONES] jack,
are muted.
NOTE
Output level settings apply individually to each DME64N/24N
unit. There is no overall device group setting.
This function cannot be accessed from the ICP1 control panel.
NOTE
The same procedure is used for scene recall from an ICP1 control panel.
CAUTION