Yamaha DSP-AZ1 - Manual (Page 82)

E-
80
REMOTE CONTROL FEATURES
Clearing learned functions, macros, renamed source names, and setup
manufacturer codes
You can reset the remote control to its factory setting by clearing the changed Libraries, programmed macros, set manufacturer codes and
learned functions.
1 1 Press CLEAR by using a ballpoint pen or similar
object.
Caution
• If you do not press any button within 30 seconds after step 1,
the clearing process is canceled. If this happen, start over
from step 1.
2 2 Press / to select the clear mode.
There are six clearing modes as shown below.
L:(name of a component) :
Clears all learned functions for the component area.
Press the input selector button to select the compo-
nent.
L:AMP : Clears all learned functions for this unit control
area.
L:ALL : Clears all learned functions.
M:ALL : Clears all programmed macros.
RNAME : Clears all renamed source names in the display
window.
FCTRY : Clears all programmed functions including setup
manufacturer codes. This returns to the factory
settings.
TRANSMIT RE–NAME CLEAR LEARN MACRO OFF ON
MACRO
SYSTEM
POWER STANDBY V–AUX TUNER PHONO
CABLE SAT MD/TAPE CD–R CD
D–TV/LD VCR 1 VCR 2 VCR3/DVR DVD
6CH INPUT
TITLE
SOURCE
SEARCH
POWER STOP PAUSE PLAY REC
CHAPTER SELECT
ENTER
DISPLAY MENU SOUND
1, 3, 4
2
CLEAR CLEAR
ENTER
3 3 Press and hold CLEAR again for about 3 seconds.
“C:OK” appears in the display window.
Caution
• “C:NG” appears in the display window if the operation is
unsuccessful. In this case, start over from step 2.
4 4 Press CLEAR to exit from the clearing mode.
Once you have cleared a learned function or macro for a
button, the button reverts to the factory setting.
Caution
• “ERROR” appears in the display window under the following
circumstances:
1 when pressing a button other than the cursor and ENTER
2 when pressing more than one button at once
3 when MACRO ON/OFF, 10KEY/DSP or PARAMETER/
SET MENU is switched to another position
CLEAR
C:OK
CLEAR