Specifications – Yamaha RX-V670 User Manual
Page 28
28
AUDIO SECTION
Minimum RMS Output Power per Channel
Front L,R
8 ohms, 20 Hz to 20 kHz, 0.03% THD.......70W+70W
6 ohms, 20 Hz to 20 kHz, 0.05% THD
[U.S.A. and Canada models only] .......80W+80W
Center
8 ohms, 1 kHz, 0.08% THD ...............................70W
Rear L,R
8 ohms, 1 kHz, 0.3% THD ......................25W+25W
Dynamic Power per Channel
(by IHF Dynamic Headroom measuring method)
8/6/4/2 ohms
[U.S.A., Canada and General models]
.................................................90/105/130/155W
[Australia model] ......................85/100/125/150W
Dynamic Headroom
8/6 ohms
[U.S.A., Canada and General models]
....................................................1.09 dB/1.18 dB
Input Sensitivity/Impedance
PHONO MM ...............................2.5 mV/47 k-ohms
CD/TUNER/TAPE/LD.TV/VCR...150 mV/47 k-ohms
MAIN IN.............................................1V/47 k-ohms
Maximum Input Signal (1 kHz, 0.02% THD)
PHONO MM..................................................80 mV
Output Level/Impedance
REC OUT ....................................150 mV/1 k-ohms
PRE OUT .........................................1V/3.3 k-ohms
Headphone Jack Rated Output/Impedance
8 ohms, 1 kHz, 0.01% THD
Output Level.....................................................0.5V
Impedance...............................................390 ohms
Frequency Response (20 Hz to 20 kHz)
CD/TUNER/TAPE/LD.TV/VCR ..................0±0.5 dB
MAIN IN ....................................................0±0.5 dB
RIAA Equalization Deviation
PHONO MM..............................................0±0.5 dB
Total Harmonic Distortion (20 Hz to 20 kHz)
PHONO MM to REC OUT (1V) .....................0.01%
CD/TUNER/TAPE/LD.TV/VCR to SP OUT (35W/8
ohms) ..........................................................0.015%
MAIN IN to SP OUT(35W/8 ohms)..............0.015%
Signal-to-Noise Ratio (IHF-A Network)
PHONO MM (5 mV Input Shorted)
......................................................More than 86 dB
CD/TUNER/TAPE/LD.TV/VCR (Input Shorted)
......................................................More than 95 dB
Residual Noise (IHF-A Network).....................120
µ
V
Channel Separation (Vol. –30 dB)
PHONO MM (Input Shorted 1 kHz/10 kHz)
.............................................................65 dB/50 dB
CD/TUNER/TAPE/LD.TV/VCR
(Input 5.1 k-ohms Terminated 1 kHz/10 kHz)
.............................................................65 dB/50 dB
Tone Control Characteristics
BASS:
Boost/cut ........................±10 dB (20 Hz)
Turnover Frequency ...................350 Hz
TREBLE:
Boost/cut ..................±10 dB (20 kHz)
Turnover Frequency...............3.5 kHz
VIDEO
Video Input Level/Impedance..................1V/75 ohms
Video Output Level/Impedance...............1V/75 ohms
FM SECTION
Tuning Range
[U.S.A. and Canada models]
................................................87.5 to 107.9 MHz
[Australia and General models]
................................................87.5 to 108.0 MHz
50 dB Quieting Sensitivity (IHF, 75 ohms)
Mono ..........................................1.55
µ
V (15.1 dBf)
Stereo............................................21
µ
V (37.7 dBf)
Usable Sensitivity (75 ohms)
(30 dB S/N Quieting, 1 kHz, 100% mod.)
.......................................................0.8
µ
V (9.3 dBf)
Image Response Ratio .....................................45 dB
IF Response Ratio ............................................80 dB
Spurious Response Ratio .................................70 dB
AM Suppression Ratio ......................................55 dB
Capture Ratio...................................................1.5 dB
Alternate Channel Selectivity ...........................85 dB
Signal-to-Noise Ratio
(IHF) Mono/Stereo ..............................81 dB/76 dB
Harmonic Distortion
Mono/Stereo (1 kHz) .................................0.1/0.2%
Stereo Separation (1 kHz) ................................50 dB
Frequency Response
20 Hz to 15 kHz .......................................0 ±1.5 dB
AM SECTION
Tuning Range
[U.S.A., Canada and General models]
..................................................530 to 1,710 kHz
[Australia model] .......................531 to 1,611 kHz
Usable Sensitivity .......................................100
µ
V/m
Selectivity..........................................................32 dB
Signal-to-Noise Ratio ........................................50 dB
Image Response Ratio .....................................40 dB
Spurious Response Ratio .................................50 dB
Harmonic Distortion............................................0.3%
AUDIO SECTION
Output Level/Impedance
FM (100% mod., 1 kHz) ...........700 mV/3.8 k-ohms
AM (30% mod., 400 Hz)...........200 mV/3.8 k-ohms
GENERAL
Power Supply
[U.S.A. and Canada models] ......AC 120V, 60 Hz
[Australia model] .........................AC 240V, 50 Hz
[General model]
..........................AC 110/120/220/240V, 50/60 Hz
Power Consumption
[U.S.A. model] .............................................240W
[Canada model] .............................390 VA, 310W
[General model] ..........................................240W
[Australia model] .........................................240W
AC Outlets
2 SWITCHED OUTLETS
[U.S.A. and General models]
...................................................100W max. total
[Canada model] ............................80W max. total
1 SWITCHED OUTLET
[Australia model].........................100W max. total
Dimensions (W x H x D)
.............................................435 x 151.3 x 296.7 mm
(17-1/8” x 5-15/16” x 11-11/16”)
Weight......................................10.5 kg (23 lbs. 2 oz.)
Accessories.....................................AM loop antenna
Indoor FM antenna
Remote control transmitter
Batteries
User program sheets
Specifications are subject to change without notice.
SPECIFICATIONS