Yamaha RX-V670 - Manual (Page 16)

16
TUNING OPERATIONS
Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is
possible. However, if signals of the station you want to select are weak, you must tune to it manually (MANUAL TUNING).
Display information ➀
Displays the band and frequency of the received station.
➁
Indicates the signal level of the received station.
➂
Illuminates when an FM stereo broadcast with sufficient
signal strength is received.
Select the reception band (FM or AM) while watching
the display.
To tune to a higher frequency, press the right side once.
To tune to a lower frequency, press the left side once.
If the station where tuning search stopped is not the
desired one, follow step 3 again.
* If the tuning search does not stop at the desired station
(because the signals of the station are weak), change to
the MANUAL TUNING method.
Select the reception band (FM or AM) while watching
the display.
Tune to the desired station manually.
* To continue tuning search, press and hold the button.
Note
If you tune to a FM station manually, it is received in monaural
mode automatically to increase the signal quality.
AUTOMATIC TUNING MANUAL TUNING
1
2
3
4
1 1
2 2
3 3
FM/AM
AM AM or
TUNING MODE
AUTO/MAN’L MONO
TUNING
kHZ
MHz
AM
FM
MEMORY AUTO
NCERT
HALL
FM/AM
AM AM or
“AUTO TUNING”
goes out.
TUNING MODE
AUTO/MAN’L MONO
STEREO
0 MHz 40 60 80 100 FM
3, 4, 3 3 2, 2 2
1, 1 1
1
3
2