Zanussi ZCG 611 - Manual (Page 5)

5
Operation
Hob burners
F
To light a burner:
- Push the electric ignition button which is marked with
a little spark ( ).
- At the same time push in and turn the relevant control
knob anticlockwise to maximum position.
- Then adjust the flame as required.
If the burner does not ignite, turn the control knob to
zero, and try again.
When switching on the mains, after installation or
a power cut, it is quite normal for the spark
generator to be activated automatically.
To ensure maximum burner efficiency, you should only
use pots and pans with a flat bottom fitting the size of
the burner used (see table).
If you use a saucepan which is smaller than the
recommended size, the flame will spread beyond
the bottom of the pan, causing the handle to
overheat.
Burner minimum maximum
diameter diameter
Large (rapid) 180 mm. 260 mm.
Medium (semi-rapid) 120 mm. 220 mm.
Small (Auxiliary) 80 mm. 160 mm.
As soon as a liquid starts boiling, turn down the
flame so that it will barely keep the liquid
simmering.
Take care when frying food in hot oil or fat, as the
overheated splashes could easily ignite.
If the control knobs become difficult to turn, please
contact your local Service Force Centre.
140
160
200
240
Oven Function Control Knob
l
Oven switched off
l - max
Range of temperature regulation for gas
oven
Grill - The heat comes only from the top
element
Grill function pilot light
The grill function pilot light will come on when the oven
function control knob is turned to
.
Oven light push button
This button will turn the oven light on.
Gas oven and Electric grill