Zanussi ZCG 611 - Manual (Page 14)

14
Cleaning around the flame
spreader
- Remove the small flap.
- Slide forward the remainder of the lid.
- Lift from the back.
When cleaning around the flame spreader, particles can
fall into the drawer below. We recommend placing some
paper over the contents of the drawer whilst cleaning.
Please ensure the paper is removed after cleaning or it
may ignite.
We advise using a stiff dry brush to remove stubborn
grease deposits around the base of the unit (see Fig.).
Remove any remaining surface fat with a sponge while
the oven is still warm.
Place a brush or other suitable cleaning implement into
the aperture and brush around the base of the unit with a
suitable detergent.
UNDER NO CIRCUMSTANCES SHOULD THE
FLAME SPREADER BE REMOVED.
After cleaning, replace the lids correctly.
FO 0177
Oven Shelves
To clean the oven shelves, soak in warm soapy water
and remove stubborn marks with a well wetted soap
impregnated pad. Rinse well and dry with a soft cloth.
FO 0287
Oven Cavity
The enamelled oven cavity is best cleaned whilst the
oven is still warm.
Wipe the oven over with a soft cloth soaked in warm
soapy water after each use. From time to time it will be
necessary to do a more thorough cleaning, using a
proprietary oven cleaner.
F
Replacing the Oven Light
Disconnect the appliance.
If the oven bulb needs replacing, it must comply with the
following specifications:
- Electric power: 15W,
- Electric rate: 230-240 V (50 Hz),
- Resistant to temperatures of 300°C,
- Connection type: E14.
These bulbs are available from your local Service Force
Centre.
F
To replace the faulty bulb:
1. Ensure the oven is disconnected from the electrical
supply.
2. Turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace with the new one.
4. Refit the glass cover.
5. Reconnect to the electrical supply.