Xantrex Technology Link 2000 - Manual (Page 27)

3-2 975-0343-01-01
Digital
Display shows
voltage and
charging
current but not
Charge %
during
charging Unit is normal, as the
charge % reading is
disabled when unit is
charging a battery
Digital
Display shows
Charge % but
not voltage
and charging
current Unit is normal. With no
AC connected to the unit,
the digital display will
only show battery capacity
(in %) when it is
connected
Digital display
always shows
0 when the
battery is
connected The battery being charged
is below 2.5 VDC
Poor connection on
battery terminals
The red Incorrect
Connection indicator light
is illuminated indicating
that the positive and
negative charging cable
clips are reversed
Battery cannot be charged
Check battery connections
Reconnect the charger cable
clips to the correct polarity (see
“To charge your 12 volt battery:”
on page 2-3)
Charging
Error E01
Bad Battery
Shutdown Battery is not accepting
charge
Charging rate selected is
too low for the battery
being charged
For flooded battery, try
reconditioning the battery (see
“To recondition your batteries
(on the vehicle):” on page 2-6)
Select a higher charge rate (see
Table 2-2 or Table 2-2 on
page 2-5)
Table 3-1 Troubleshooting reference
Problem Possible Cause Solution
Duracell_Charger15.book Page 2 Friday, June 15, 2007 2:34 PM