Xerox KS-801 - Manual (Page 18)

-18-
Duplex Mode Setting
The duplex mode used for the fiber module is configured by software
port control settings. See chapter 5 for more information.
Specifications
Standard IEEE 802.3u 100BASE-FX
Speed 100Mbps
Duplex mode Full duplex or half duplex
Wavelength 1300nm
Fiber Connectors ST, SC, MT-RJ, VF-45
Fiber cable MM 50/125 m m, 62.5/125 m m recommended
SM 9/125 m m recommended
Module Installation
1. Turn off the power to the switch unit.
2. Open the cover of Fiber slot.
3. Set Fiber jumper J1.
4. Insert the module into slot until it is seated properly.
5. Screw the module onto the chassis securely.