Yamaha HTR-6130 - Manual (Page 36)

32
En
Playback
■ Adjusting speaker levels during
playback
You can adjust the output level of each speaker while
listening to a music source.
This operation will override the level adjustment made in “SP
LEVEL” (see page 46).
1
Press 4
AMP and then press 6LEVEL
repeatedly to select the speaker you want to
adjust.
y
Once you press 6LEVEL on the remote control, you can
also select the speaker by pressing 7k / n.
2
Press 7l / h on the remote control to
adjust the speaker output level.
The control range is from –10 dB to +10 dB.
y
You can press DA/B/C/D/E to select a speaker and then
EPRESET/TUNING l / h to adjust the speaker output level.
■ Displaying the signal information
You can display the format, sampling frequency, channel,
bit rate and flag data of the current input signal.
1
Press 4
AMP and then press HMENU on
the remote control.
“BASIC SETUP” appears in the front panel display.
;BASIC SETUP
2
Press 7k / n repeatedly to select “SIGNAL
INFO” and then press 7
ENTER.
3
Press 7k / n to switch the displayed
information.
The following information about the input source
appears in the front panel display.
4
Press H
MENU to exit.
Note
Display Adjusted speaker
FRONT L Front left speaker
FRONT R Front right speaker
CENTER Center speaker
SWFR Subwoofer
SUR.L Surround left speaker
SUR.R Surround right speaker
Display Description
Format Signal format.
Sampling
frequency The number of samples per second taken
from a continuous signal to make a discrete
signal.
Channel The number of source channels in the input
signal (front/surround/LFE).
Bit rate The number of bits passing a given point
per second.
Flag data Flag data encoded in DTS, Dolby Digital,
or PCM signals that cue this unit to
automatically switch decoders.
01EN_RX-V363_U.book Page 32 Thursday, January 31, 2008 3:52 PM