beautypg.com

Connecting the fm and am antennas, Connecting the power cable, Turning on and off the power – Yamaha HTR-6130 User Manual

Page 23: P. 19, Turning on this unit, Set this unit to the standby mode, Connecting the wire of the am loop antenna y, Assembling the supplied am loop antenna

background image

19

En

Connections

PREP

ARA

TION

English

Both FM and AM indoor antennas are supplied with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.

• The AM loop antenna should be placed away from this unit.
• A properly installed outdoor antenna provides clearer reception

than an indoor one. If you experience poor reception quality,
install an outdoor antenna. Consult the nearest authorized
Yamaha dealer or service center about outdoor antennas.

• The AM loop antenna should always be connected, even if an

outdoor AM antenna is connected to this unit.

Connecting the wire of the AM loop antenna

y

The wire of the AM loop antenna does not have any polarity
and you can connect either end of the wire to AM or GND
terminal.

Assembling the supplied AM loop antenna

The types of the supplied AM loop antenna is different
depending on the models.

Once all connections are complete, plug the power cable
into the AC wall outlet.

Turning on this unit

Press A

STANDBY/ON (or D POWER) to turn

on this unit.

y

When you turn on this unit, there will be a 4 to 5-second delay
before this unit can reproduce sound.

Set this unit to the standby mode

Press A

STANDBY/ON (or E STANDBY) to set

this unit to the standby mode.

In the standby mode, this unit consumes a small amount of power
in order to receive infrared signals from the remote control.

Connecting the FM and AM
antennas

Notes

DEO

ANTENNA

R SURRO

AUDIO

OUTP

DVR

CD

S

N

OUT

DVR

AM

GND

FM

UNBAL.

75

N

OUT

MONITOR

OUT

MD/

CD-R

OUT

(REC)

IN

(PLAY)

AM loop
antenna
(supplied)

Ground

For maximum safety and minimum
interference, connect the antenna GND
terminal to a good earth ground. A good earth
ground is a metal stake driven into moist earth.

Indoor FM
antenna
(supplied)

Outdoor AM antenna

Use a 5 to 10 m (16 to 32
ft) of vinyl-covered wire
extended outdoors from a
window.

Open the

lever

Insert

Close the

lever

Note

Connecting the power cable

Turning on and off the power

Note

(U.S.A. model)

Power cable

To the AC wall outlet

01EN_RX-V363_U.book Page 19 Thursday, January 31, 2008 3:52 PM