ZyXEL Communications 2-Slot 10GBase-CX4 10Gigabit Module EM-412 - Manual (Page 3)

3
EM-412 User’s Guide
1 Hardware Installation
Follow these steps to install the EM-412 in a switch.
"
Modules are NOT hot swappable!
1 Turn off your switch and unplug all power supply cords
(including any backup power supply cords) from the
switch.
2 Loosen the screws from the
cover plate and remove the
cover plate from an
expansion slot on the switch.
Do not discard the cover
plate. You can put the cover
plate back on if you remove
the new module.
"
Before you continue, wear an anti-static wrist
strap or touch any grounded or metal objects to
discharge any bodily static electricity.
3 Remove the EM-412 from its protective anti-static
packaging. Hold the EM-412 by its edge to avoid touching
the onboard circuit components.