Zanussi ZBB26650SA User Manual

Page 13

Remove the correct

part from the hinge cover

(E). Make sure to remove

the part DX, in the case of

right hinge, SX in oppo-

site case.

Attach the covers (C,

D) to the lugs and the

hinge holes.

Install the vent grille (B).

Attach the hinge covers (E)

to the hinge.

Fix the appliance to

the side of the kitchen

unit, fit the bracket (E) and

(F), adjust the distance,

and fix using the screws

(as in figure).

Fit the cover (D).

Disconnect the parts

(Ha), (Hb), (Hc) and (Hd).

21 mm

~50 mm

Install the part (Ha) on

the inner side of the kitch-

en furniture.

Push the part (Hc) on

the part (Ha).

8 mm

Open the appliance

door and the kitchen fur-

niture door at an angle of

90°.

Insert the small square

(Hb) into guide (Ha).

Put together the appliance

door and the furniture

door and mark the holes.

8 mm

Remove the brackets

and mark a distance of 8

mm from the outer edge of

the door where the nail

must be fitted (K).

Place the small square

on the guide again and fix

it with the screws sup-

plied.

Align the kitchen furniture

door and the appliance

door by adjusting the part

Hb.

Press the part (Hd) on

the part (Hb).

Do a final check to make sure that:
• All screws are tightened.
• The magnetic sealing strip is attached tightly to the

cabinet.

Important! If the ambient temperature is low (for example,

in the Winter), the size of the gasket decreases. The size of

the gasket increases when the ambient temperature

increases.