Technical data, Installation – Zanussi ZBB26650SA User Manual
Page 10

Problem
Possible cause
Solution
Plug is not connected to the mains
socket properly
Connect the mains plug properly
Power does not reach the appliance
Try connecting another electrical device
to the power outlet
There is no voltage in the mains sock-
et (try to connect another appliance in-
to it)
Call an electrician
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
1. Press on the rear hook and at the same time slide the
cover in the direction of the arrow.
2. Replace the lamp with one of the same power and
specifically designed for household appliances. (the
maximum power is shown on the light bulb cover).
3. Install the lamp cover by fixing it into its original po-
sition.
4. Connect the plug to the mains socket.
5. Open the door. Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
Technical data
Dimension of the recess
Height
1780 mm
Width
560 mm
Depth
560 mm
Rising Time
25 h
Voltage
230-240 V
Frequency
50 Hz
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.
Installation
Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
10
www.zanussi.com