Zanussi ZBB26650SA User Manual

Page 11

Positioning

Install this appliance at a location where the ambient tem-

perature corresponds to the climate class indicated on the

rating plate of the appliance:

Climate

class

Ambient temperature

+10°C to + 32°C

+16°C to + 32°C

+16°C to + 38°C

+16°C to + 43°C

Electrical Connection

Caution! Any electrical work required to install this

appliance should be carried out by a qualified

electrician or competent person.

Warning! This appliance must be earthed.

The manufacturer declines any liability should these

safety measures not be observed.

Important! The wires in the mains lead are coloured in

accordance with the following code:

A Green and Yellow:

Earth

C Brown:

Live

D Blue:

Neutral

As the colours of the wires in the mains lead of this appli-

ance may not correspond with the coloured markings

identifying the terminals in your plug, proceed as follows:
1. Connect the wire coloured green and yellow to the

terminal marked either with the letter “E“ or by the
earth symbol or coloured green and yellow.

2. Connect the wire coloured blue to the terminal either

marked with the letter “N“ or coloured black.

3. Connect the wire coloured brown to the terminal ei-

ther marked with the “L“ or coloured red.

4. Check that no cut, or stray strands of wire is present

and the cord clamp E is secure over the outer sheath.

5. Make sure the electricity supply voltage is the same

as that indicated on the appliance rating plate.

6. Switch on the appliance.

The appliance is supplied with a 13 amp plug fitted B. In

the event of having to change the fuse in the plug sup-

plied, a 13 amp ASTA approved (BS 1362) fuse must be

used.

Warning! A cut off plug inserted into a 13 amp

socket is a serious safety (shock) hazard. Ensure

that it is disposed of safely.

Door reversibility

The door of the appliance opens to the right. If you want to

open the door to the left, do these steps before you install

the appliance:

Loosen the upper pin

and remove the spacer.

Remove the upper pin

and the upper door.

Loosen the middle

hinge.