SUUNTO X6HR - Manual (Page 9)

7
�
� � � � �
�����
� � � � �
�����




1.3. ADJUSTING THE BRACELET
(SUUNTO X6
hrt
)
the metal/elastomer bracelets of the Suunto X6
hrt
have to be adjusted for the user. the steps are
. remove the buckle by releasing the spring bars
with pin, paper clip or other sharp object.
. remove both spring bars from the pin holes.
3. Shorten the bracelet by cutting along the grooves
on the inner surface of the bracelet. You can do
this for instance with scissors. If you are unsure
of the correct length, cut the pieces one by one
and test the length after cutting each piece. Cut
in turns from both sides of the bracelet to keep
the sides equally long. Be careful in order not to
shorten the bracelet too much.
4. replace the spring bars into the last pin holes
of both sides of the bracelet.
5. attach the buckle to the bracelet by placing the
spring bars into the holes in the buckle. In both
sides of the buckle are holes for two different
positions. this can be used for fine adjusting of
the bracelet length. make sure that the spring
bars are positioned straight in the buckle.