Yamaha HTR-6160 - Manual (Page 120)

116
En
Troubleshooting
■ iPod
In case of a transmission error without a status message appearing in the front panel and in the OSD, check the connection to your iPod
(see page 25).
■ Bluetooth
Note
Status message Cause Remedy
See
page
Loading... This unit is in the middle of recognizing the
connection with your iPod.
This unit is in the middle of acquiring song
lists from your iPod.
Connect error There is a problem with the signal path
from your iPod to this unit. Turn off this unit and reconnect the Yamaha iPod
universal dock to the DOCK terminal of this unit. 25
Try resetting your iPod. —
Unknown iPod The iPod being used is not supported by
this unit. Only iPod (Click and Wheel), iPod nano, and iPod
mini are supported. —
iPod connected Your iPod is properly stationed in a
Yamaha iPod universal dock (such as YDS-
10, sold separately) connected to the
DOCK terminal of this unit, and the
connection between your iPod and this unit
is complete.
Disconnected Your iPod was removed from a Yamaha
iPod universal dock (such as YDS-10 sold
separately) connected to the DOCK
terminal of this unit. Station your iPod back in a Yamaha iPod universal
dock (such as YDS-10 sold separately) connected to
the DOCK terminal of this unit. 25
Unable to play This unit cannot play back the songs
currently stored on your iPod. Check that the songs currently stored on your iPod are
playable. —
Store some other playable music files on your iPod. —
Status message Cause Remedy
See
page
Searching... The Bluetooth adapter and the Bluetooth
component is in the middle of the pairing.
The Bluetooth adapter and the Bluetooth
component is in the middle of establishing
the connection.
Completed The paring is completed.
Canceled The paring is canceled.
BT connected The connection between the Yamaha
Bluetooth adapter (such as YBA-10, sold
separately) and the Bluetooth component is
established.
Disconnected The Bluetooth component is disconnected
from the Yamaha Bluetooth adapter (such
as YBA-10, sold separately).
No BT adapter The Bluetooth adapter is not connected to
the DOCK terminal. Connect the Yamaha Bluetooth adapter (such as YBA-
10, sold separately) to the DOCK terminal. 25
BT Error This unit detects a problem of the
connected Bluetooth adapter. Set this unit to the standby mode and then turn on
again. —