Zenoah RedMax PSZ2401 - Manual (Page 46)

46
MA6
MA7
MA8
■ SAW CHAIN
It is very important for smooth and safe operation
to keep the cutters always sharp.
Your cutters need to be sharpened when:
• Sawdust becomes powder-like.
• You need extra force to saw in.
• The cut way does not go straight.
• Vibration increases.
• Fuel consumption increases.
Cutter setting standards:
Be sure to wear safety gloves.
Before filing:
• Make sure the saw chain is held securely.
• Make sure the engine is stopped.
• Use a round file of proper size for your chain.
Chain type: 90SG
File size: 5/32 in (4.0mm)
Place your file on the cutter and push straight forward.
Keep the file position as illustrated. (MA6)
After every cutter has been set, check the depth gauge
and file it to the proper level as illustrated. (MA7)
Be sure to round off the front edge to reduce the
chance of kickback or tie-strap breakage.
(1) Appropriate gauge checker
(2) Make the shoulder round
(3) Depth gauge standard
Make sure every cutter has the same length and edge
angles as illustrated. (MA8)
(4) Cutter length
(5) Filing angle
(6) Side plate angle
(7) Top plate cutting angle
WARNING
WARNING
WARNING
9. Maintenance
English