Zenoah RedMax PSZ2401 - Manual (Page 22)

22
■ MOUNTING ENGINE (SE1)
1. Push the driveshaft housing toward the clutch
housing and rotate it by hand to check that the
driveshaft is engaged with the gears.
2. Insert the driveshaft housing into the clutch housing
until it bottoms, and align the positioning holes on
the both housings and install the screw.
3. Fasten the clamp securely with 2 screws.
■ CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on
the top of the carburetor. (SE2)
■ CONNECTING SWITCH WIRES (SE3)
• Connect the switch wires between the engine and
the main unit. Pair the wires of the same color.
• Bind switchwires to throttle wire with tie band like
figure of SE3.
(1) Tie band
■ ATTACHING THE PRUNING MECHANISM (SE4)
1. Remove the cap on the end of the main pipe.
2. Remove the screw screwed into the end of the gear
case.
3. Insert the end of the gear case into the main pipe.
4. Line up the hole on the end of the gear case into
which the screw is to be inserted with the hole on the
main pipe, and screw the screw firmly in.
5. Using a wrench, screw in the bolt provided to fix the
mechanism into place.
(1) Main pipe
(2) Gear case
(3) Screw hole
(4) Fastening bolt
(5) Bolt
SE1
SE2
SE3
(1)
(2)
(3)
(4)
(5)
SE4
6. Set up
English