Zanussi DW 24 - Manual (Page 24)

Adjusting the Worktop
You can move the worktop forward or backward by 25
mm in order to align the machine with other kitchen
units.
Simply unscrew the two front retaining screws, move
the top to the required position and then retighten the
screws.
Installing and Securing the
Machine Under a Kitchen
Unit (Sink-Worktop Unit)
By removing the machine’s worktop, you can install it
under a close fitting sink unit or a pre-existing top, if the
dimensions of the recess correspond to those shown in
the picture.
Then proceed as follows:
Remove the machine worktop by unscrewing the two
rear retaining screws, pull from the front and slide out
the rear slots, lifting the worktop.
Insert the machine after adjusting the height and
levelling with the adjustable feet. When inserting the
machine, ensure that the water inlet and drain hoses are
not kinked or squashed.
Caution
Once the machine has been installed, ensure that it is
easily accessible for servicing.
It is absolutely essential that the dishwasher is
disconnected from the electricity supply before gaining
access to any internal component.
Levelling
Good levelling is essential for correct closure and
sealing of the door.
When the appliance is correctly levelled, the door will
not catch on the levelling spacers, either side of the
cabinet.
If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
24 PFI11UK
820
570 ÷
600
450
IN04
IN06 IN07
IN02