Zanussi DW 24 - Manual (Page 14)

1. Check the filters
Ensure they are clean and properly positioned
(see cleaning instructions).
2. Check that there is rinse
aid and salt
3. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the basket back into the machine.
4. Ensure that the spray
arms can rotate freely.
5. Measure out detergent
Add the required amount of detergent into the
dispenser according to the "Washing
programmes" chart and close the lid.
6. Close the detergent
dispenser lid
7. Select the programme
Close the door.
Turn the programme selector dial clockwise
until the programme letter you wish to select
corresponds with the programme marker on the
control panel.
8. Start the programme
Depress the On/Off pushbutton. The On/Off
indicator light comes on and the machine will
start.
9. At the end of the
washing programme
At the end of the washing programme the
dishwasher stops automatically. The On/Off
indicator light remains on until the On/Off
pushbutton is depressed.
10. Switch off the
dishwasher
Switch off the dishwasher by pressing the
On/Off pushbutton.
When the wash programme has
finished, it is recommended that the
dishwasher is unplugged and the
water tap turned off.
In general it is not advisable to open
the door while the machine is
working. If the door is opened
however, a safety device ensures
that the machine stops.
Care must be taken if the door is
opened during the hot phase or
immediately after a programme has
finished, as steam may escape.
Operating sequence
14 POS04UK