ZyXEL Communications PLA-407 - Manual (Page 33)

Chapter 4 The ENCRYPT Button
PLA-407 User’s Guide
33
4.2.1 Expanding the Network with ENCRYPT
If you want to add more Powerline devices to your network after the initial setup
(refer to
Section 4.2 on page 31 ), do the following.
1 To add more Powerline devices to your network, press the ENCRYPT button on
device C (shown below) for more than 10 seconds until the power (
) light
flashes.
2 Then repeat steps 4 and 5 in the previous section using any Powerline device (A or
B) you have connected using ENCRYPT and the Powerline device you want to
connect (C). You must use the ENCRYPT button on both devices.
Figure 11 Adding More Powerline Adapters to Your Network
3 If you have previously disconnected your computer or modem (or any other
networking product connected to your Powerline device), you can now reconnect
them.
This sets up your Powerline network between your Powerline devices.
4.3 Setting Up Multiple Networks
You can use the ENCRYPT button to set up multiple Powerline networks using
your existing Powerline network.
A or B
A B
C