ZyXEL Communications PLA-407 User Manual
Page 32
Chapter 4 The ENCRYPT Button
PLA-407 User’s Guide
32
4
Press the ENCRYPT button on your second Powerline device for 1~2 seconds. The
power (
) light will blink as the PLA-407 tries to set up a connection.
Figure 10 ENCRYPT Connection Procedure
Note: The ENCRYPT button’s location varies for each Powerline device.
5
in this section for any other Powerline device you wish to connect.
This must be done within 60 seconds of pressing the ENCRYPT button on the
PLA-407.
6
Check the lights on the Powerline devices. The power (
) and HomePlug (
)
lights should be blinking while the devices are connecting. Several times all lights
blink simultaneously and the HomePlug (
) light also shows red. Wait for about
one minute while your Powerline devices connect.
If the power (
) light does not blink when you press ENCRYPT, you have
probably pressed the ENCRYPT button for too long. Try again, pressing the
ENCRYPT button for 1~ 2 seconds.
If the HomePlug (
) lights on both Powerline devices do not light up, the
Powerline devices are not connected. Repeat steps 4 and 5 in this section. If
that doesn’t work, see the Troubleshooting in Section 9.5 on page 82 for
suggestions.
within 2 minutes
press for
2 seconds
press for
2 seconds