XM Satellite Radio R-672 - Manual (Page 17)

17
Adjusting the tone (bass and treble)
• The tone mode is displayed for several seconds.
Note : When the digital signals from DTS, Dolby Digital
program sources are input or the EXTERNAL IN is
selected can listen to a program source without
the tone effect.
When the “TONE” is set to ON to adjust the
tone (bass and treble).
• The tone level can be adjusted within the range of -10 ~
+10 dB.
• In general, we recommend the bass and treble to be
adjusted to 0 dB (flat level).
• Extreme settings at high volume may damage your
speakers.
• To complete tone adjustment, repeat the above steps 11
and 12.
• If the tone display disappears, start from the step 9
again.
• Each time these buttons are pressed, the tone mode is
selected as follows:
OFF : To listen to a program source without the tone
effect. (“DIRECT” indicator lights up.)
ON : To adjust the tone for your taste.
(“DIRECT” indicator goes off.)
• Each time these buttons are pressed, the tone is
selected as follows:
BASS TRBL(treble) TONE ON
9.
Enter the tone mode.
10.
Press the CURSOR LEFT( )/RIGHT( ) buttons to
select the desired tone mode.
11.
Press the CURSOR UP( )/DOWN( ) buttons to
select the desired tone.
12.
Press the CURSOR LEFT( )/RIGHT( ) buttons to
adjust the selected tone as desired.
ENGLISH