Step 2 install the device drivers, P. 21, 22), 2 install the device drivers – Yamaha CD Recordable/Rewritable Drive CRW-70 User Manual
Page 30
21
7
77
7
Connect the USB cable provided to the computer.
Insert the series A plug (with a rectangular cross section) of the USB
cable provided in the USB port of the interface card.
When the CRW-70 drive and computer are connected, the busy LED
flashes green and then lights up orange and “PC” shows on the display.
• Be sure to connect the drive to the USB port of the computer. If you connect the
drive to the computer via a USB hub, the drive may not operate properly.
• If the CRW-70 drive is connected to a USB 1.1 port, which is one of the typical
USB ports installed as standard on computers, the drive operates in accordance
with USB 1.1 standard. (
As soon as the CRW-70 drive is connected to the computer, it automatically
starts installing the device drivers. The device drivers only need to be
installed once when the CRW-70 drive is connected to the computer for the
first time.
For Windows 98 Second Edition
Install the device driver provided.
For details, refer to the separate manual, “Device Driver Installation Guide,”
that came with the CRW-70 drive.
Notes
STEP
2 Install the Device Drivers
Series A plug
USB port
USB cable
(provided)