Yamaha EMX-220VCD - Manual (Page 20)

E-12
CONNECTIONS
SPEAKERS CENTER/REAR VOLTAGE SELECTOR
SPEAKERS FRONT AC OUTLET
MAINS
R L CENTER REAR REAR
REAR SINGLE
CENTER :6 Ω MIN./SPEAKER
6 Ω MIN./SPEAKER
SEE OWNER’S MANUAL FOR CONNECTION.
SEE OWNER’S MANUAL FOR CONNECTION.
REAR :4 Ω MIN./SPEAKER REAR SINGLE :8 Ω MIN./SPEAKER
R L
UNSWITCHED 100W MAX.
L
AUDIO SIGNAL TAPE/MD LD/TV
AUDIO SIGNAL
VCR SUBWOOFER
R
IN OUT IN OUT
OUT
VCR MONITOR OUT LD/TV
VIDEO SIGNAL
ANTENNA
AM
FM
GND
75 Ω UNBAL.
NORMAL AUTO 50kHz
9kHz 10kHz NTSC
100kHz
FM
AM PHANTOM PAL
CENTER MODE TV MODE FREQUENCY STEP IN OUT
VIDEO SIGNAL
To AC outlet
Connecting external components
(See figure
8
on page 8 8 .)
This unit can be connected with external audio and video
components. Make connections between this unit and other
components using RCA pin plug connector cables correctly,
that is to say L (left) to L and R (right) to R. Also, refer to the
owner’s manual for each component to be connected to this
unit.
* : AC OUTLET (UNSWITCHED)
The power cord of any audio/video unit can be connected to
this outlet.
The power to this outlet is not controlled by this unit’s
STANDBY/ON switch . This outlet will supply power to the
connected unit even if this unit is in the standby mode.
The maximum power that can be connected to this outlet is
100 watts
Setting the video output format
selector (TV MODE) switch
The Video CD player built into this unit is designed for use
with the NTSC and PAL television formats. Set this switch to
the position for the format your monitor TV employs.
PAL: Outputs signals in the PAL format no matter which
format (PAL or NTSC) the currently playing disc
employs.
Set to this position if your monitor TV employs the
PAL format.
AUTO: Outputs signals in the same format as the currently
playing disc employs.
Set to this position if your monitor TV can be
switched in between the PAL and NTSC formats
automatically.
NTSC: Outputs signals in the NTSC format no matter which
format (PAL or NTSC) the currently playing disc
employs.
Set to this position if your monitor TV employs the
NTSC format.
Note
Be sure to play back a disc which employs the same format
that your monitor TV employs, otherwise a picture will not be
played back normally.
Connecting the AC supply lead
• After completing all connections, plug the AC supply lead
into a convenient AC outlet.
•
Unplug the AC supply lead from the AC outlet if the unit is
not to be used for a long period of time.
SPEAKERS CENTER/REAR VOLTAGE SELECTOR
SPEAKERS
FRONT
AC OUTLET
MAINS
R L CENTER REAR REAR
REAR SINGLE
CENTER :6 Ω MIN./SPEAKER
6 Ω MIN./SPEAKER
SEE OWNER’S MANUAL FOR CONNECTION.
SEE OWNER’S MANUAL FOR CONNECTION.
REAR :4 Ω MIN./SPEAKER REAR SINGLE :8 Ω MIN./SPEAKER
R L
UNSWITCHED 100W MAX.
L
AUDIO SIGNAL
TAPE/MD LD/TV
AUDIO SIGNAL
VCR SUBWOOFER
R
IN OUT IN OUT
OUT
VCR MONITOR OUT LD/TV
VIDEO SIGNAL
ANTENNA
AM
FM
GND
75 Ω UNBAL.
NORMAL AUTO 50kHz
9kHz 10kHz NTSC
100kHz
FM
AM PHANTOM PAL
CENTER MODE TV MODE FREQUENCY STEP IN OUT
VIDEO SIGNAL
50kHz
9kHz
NORMAL
PHANTOM
CENTER
MODE
TV
MODE
AUTO
NTSC
PAL
(General model)
(General model)