Yamaha EMX-220VCD - Manual (Page 18)

E-10
CONNECTIONS
Connecting speakers
(See figure
6
on page 6 6 .)
Connect the front speakers to the FRONT SPEAKERS
terminals, the center speaker to the CENTER SPEAKERS
terminals and the rear speakers to the REAR SPEAKERS
terminals.
Note
Use speakers with the specified impedance shown on the
rear of this unit.
■
How to Connect:
Connect the SPEAKERS terminals to your speakers with wire
of the proper gauge, cut as short as possible. If the
connections are faulty, no sound will be heard from the
speakers. Make sure that the polarity of the speaker wires is
correct, that is the + and – markings are observed. If these
wires are reversed, the sound will be unnatural and lack bass.
Caution
Do not let the bare speaker wires touch each other as
this could damage the amplifier and/or speakers.
Note on connecting one rear speaker only
You can use one rear speaker only in place of two rear
speakers. For connecting one rear speaker, follow the
method shown below.
Red: positive (+)
Black: negative (–)
➀
Press up the tab.
➁
Insert the bare wire.
[Remove approx.
5mm (1/4”) insulation
from the speaker
wires.]
➂
Press down the tab
and secure the wire.
➀
➁
➂
Note on connecting a subwoofer (separate
purchase)
You may wish to add a subwoofer to reinforce the bass
frequencies.
Connect the SUBWOOFER OUT terminal of this unit to the
INPUT terminal of the subwoofer amplifier, and connect the
speaker terminals of the subwoofer amplifier to the
subwoofer.
With some subwoofer systems, including the Yamaha Active
Servo Processing Subwoofer System, an amplifier is
incorporated into the system.
* The SUBWOOFER OUT terminal outputs low frequencies
from the front and center channels.
(The cut-off frequency of signals output from this terminal is
200 Hz.)
■
How to connect the YAMAHA NS-P30 speaker
system (separate purchase) to this unit
(See figure
7
on page 7 7 .)
If you connect the YAMAHA NS-P30 speaker system to this
unit, read the following descriptions.
NX-E70 (Rear speakers)
●
Connect the push-type input terminals on the rear of the
speakers to the REAR SPEAKERS terminals of this unit
with the provided speaker cables.
● One side of the speaker cable has a white line and the
other side has no line. Connect the (+) terminals on both
this unit and the speakers using the side with a white line.
Connect the (–) terminals on both components using the
side with no line.
● Connect one speaker to the left (marked L) terminals of
this unit, and another speaker to the right (marked R)
terminals, making sure not to reverse the polarity (+, –). If
one speaker is connected with reversed polarity, the sound
will be unnatural and lack bass.
Procedures:
➀
Press the tab on the terminal down, as shown in the
figure.
➁
Insert the bare speaker wire end properly into the terminal
hole. [Remove approx. 5 mm (1/4”) insulation from the
speaker cable.]
➂
Remove your finger from the tab to allow it to lock snugly
on the cable’s wire end.
➃
Test the security of the connection by tugging lightly on
the cable at the terminal.
NX-C70 (Center speaker)
To connect the speaker cable from NX-C70 to the CENTER
SPEAKERS terminals of this unit, make sure to connect the
side with a white line to the (+) terminal and the side with no
line to the (–) terminal.
Never plug the AC supply lead of this unit into the AC outlet until all connections are
completed.
Rear speaker
R L CENTER REAR REAR
REAR SINGLE