Xerox DocuColor 2240 - Manual (Page 4)

Customer Release Notes
DocuColor 2240/1632 Digital Printer/Copier
Xerox Corporation
Customer Release Notes
Media
•
Use Xerox approved transparency otherwise problems may occur. Refer to Xerox recommended media list
(RML) for the correct type of transparency.
•
Coated papers are very susceptible to humidity. Multifeeds are much more likely with humidity greater than
40%. Environmental conditions may require that coated paper be fed one sheet at a time from Tray 5 (Bypass).
•
SRA3 paper is not supported directly from either PS or PCL drivers. However it can be run in a following
manner:
Using the Postscript Driver:
•
Set the Paper Size to Custom Size. Set the width to the maximum of 305mm and the length to 450mm (Note
that the correct width of SRA3 cannot be set since it is 320mm wide and the drivers only support up to
305mm).
Using the PCL Driver:
•
Set up first a Custom Paper Size for the Printer
•
Select Settings/Printers/Properties
•
On the Configuration tab select "Custom Paper Size"
•
Select one of the 5 custom sizes
•
Set Short Edge to the maximum of 305mm and Long Edge to 450mm
•
The driver will show the new custom size as one of the choices in Output Size. Select that size.
•
Select the "Print Area" button and set it to "Extended"