ZyXEL Communications P-1100 - Manual (Page 64)

Prestige 1100 Internet Access Router
6-6 IPX Configuration
6.4.1 IPX Remote Node Setup
Follow the procedure in Chapter 5 to configure the protocol-independent parameters in Menu 11.1 -
Remote Node Profile. For the IPX-related parameters in Menu 11.3 - Remote Node Network Layer
Options, follow the instructions below.
To edit Menu 11.3 - Remote Node Network Layer Options shown in Figure 6-5, follow these steps:
In Menu 11.1, make sure [IPX] is among the protocols in the Route field. (The Route field should
display Route = IPX or Route = IP + IPX.)
Move the cursor to the [Edit IP/IPX/Bridge] field, then press the space bar to toggle and set the value to
[Yes], and press [ENTER]
to edit Menu 11.3 - Network Layer Options.
Figure 6-5 Menu 11.3 - Remote Node Novell IPX Options
Menu 11.3 - Remote Node Network Layer Options
IP Options:
Rem IP Addr:
Rem Subnet Mask= N/A
My WAN Addr= N/A
Single User Account= N/A
Server IP Addr= N/A
Metric= N/A
Private= N/A
RIP Direction= N/A
Version= N/A
Multicast= IGMP-v2
IP Policies=
IPX Options:
Rem LAN Net #= 00000000
My WAN Net #= 00000000
Hop Count= 1
Tick Count= 2
W/D Spoofing(min)= 3
SAP/RIP Timeout(min)= 3
Bridge Options:
Ethernet Addr Timeout(min)= N/A
Enter here to CONFIRM or ESC to CANCEL: