Yamaha RX-V3900 - Manual (Page 64)

60
En
SIRIUS Satellite Radio™ tuning
■ All Channel Search mode
1
Press H
SEARCH MODE (or ISRCH
MODE) repeatedly to select “ALL CH
SEARCH”.
2
Press F
PRESET/TUNING/CH l / h (or
9
PRESET/CH k / n) repeatedly to search
for a channel within all channels.
y
• You can search for a channel quickly by pressing and holding
FPRESET/TUNING/CH l / h (or 9PRESET/CH k / n).
• You can skip channels to the previous or next category by
pressing JCATEGORY (or 9A-E/CAT. l / h).
■ Category Search mode
1
Press H
SEARCH MODE (or ISRCH
MODE) repeatedly to select “CAT SEARCH”.
2
Press J
CATEGORY (or 9A-E/CAT. l / h)
repeatedly to change the channel category.
3
Press F
PRESET/TUNING/CH l / h (or
9
PRESET/CH k / n) repeatedly to search
for a channel within the selected channel
category.
y
You can search for a channel quickly by pressing and holding
FPRESET/TUNING/CH l / h (or 9PRESET/CH k / n).
This unit skips the channels when this unit is in the All Channel
Search mode or Category Search mode in the following cases (it
is not malfunction of this unit):
– the channel is locked (page 62).
– the channel is out of service.
– you do not subscribe to the channel.
■ Preset Search mode
Prior to selecting a preset channel in the Preset Search
mode, you must preset SIRIUS channels. For details, see
“Setting the SIRIUS Satellite Radio™ preset channels”
(page 61).
1
Press H
SEARCH MODE (or ISRCH
MODE) repeatedly to select “PRESET
SEARCH”.
2
Press J
CATEGORY (or 9A-E/CAT. l / h)
repeatedly to change the preset channel
group (A to E).
3
Press F
PRESET/TUNING/CH l / h (or
9 PRESET/CH k / n) repeatedly to change
the preset channel number (1 to 8).
y
You can also select the preset channel number directly by
pressing the numeric buttons (1 to 8) (B).
■ Direct number access mode
1
Press I
SRCH MODE on the remote control
repeatedly to select “ALL CH SEARCH” or
“CAT SEARCH”.
2
Press the numeric buttons (B) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons (B) as shown below.
y
• To display the Sirius ID number displayed in the front panel
display, select channel “0”.
• To enter a one-digit or two-digit channel number, press the
numeric buttons (B) on the remote control and then press
NENT to confirm the input number.
• Instead of pressing NENT to tune into the channel
immediately, you can wait a few seconds until this unit confirms
the entered channel number.
• If no button is pressed within a few seconds after you enter a
one-digit or two-digit number, this unit automatically confirms
the entered channel number.
• If the selected channel is locked, “PIN:____” appears in the
front panel display. Enter the four-digit Parental Lock code
number by using the numeric buttons (B) or press NENT to
cancel (page 62).
Note
1 2 3