Yamaha RX-V3900 - Manual (Page 35)

31
En
Optimizing the speaker setting for your listening room
PRE
P
ARA
T
ION
English
y
It is recommended that you use a tripod (etc.) to affix the
optimizer microphone at the same height as your ears
would be when you are seated in your listening position.
You can use the attached screw of a tripod (etc.) to fix the
optimizer microphone to the tripod (etc.).
3 Press 9 ENTER to start the measurement.
This unit starts to count down from 10 seconds.
y
• To start the measurement immediately, press 9ENTER
again.
• To cancel the automatic setup and return to the previous
screen, press 0RETURN.
Loud test tones are output from each speaker during
the measurement. Once all items are measured,
“COMPLETED” appears.
If an error or warning message appears, see “Automatic
setup” (page 136).
4
Disconnect the optimizer microphone to
complete the automatic setup.
y
You can check the results of the measurements by using
the GUI screen (page 34).
Use this feature to optimize the setup of this unit this unit
for one listening position. You can also select the
parameters to be optimized in the automatic setup.
1
Turn on the video monitor and then follow
steps 1 and 2 in “Quick automatic setup”
(page 30).
2
Press I
MENU on the remote control.
The following screen (GUI menu) appears in the
video monitor.
3
To select the parameters to be optimized,
press 9k to select “Setup Menu” and then
press 9h.
When you do not need to select the parameters to be
optimized, skip to step 6.
y
If you do not select the parameters to be optimized, this
unit will optimize the parameters you selected last time.
All the parameters are selected by the initial factory
settings.
4
Press 9k / n repeatedly to select the
parameter and then press 9
ENTER to
check or uncheck the box.
Check the boxes for the parameters to be optimized.
Before proceeding next operation
Once you perform the next operation, this unit starts the
automatic setup procedure in 10 seconds. During the
automatic setup procedure, do not perform any operation on
this unit. For more accurate measurements, we recommended
that you get out of the room or move to the wall where
speakers are not around during the measurement. It takes
approximately 3 minutes.
Note
Optimizer microphone
C O M P L E T E D
P L S U N P L U G M I C
E R R O R : E - 0 1
P R E S S E N T E R
Basic automatic setup
Parameter Descriptions
Multi Measure
(Multiple point
measurement) You can optimize the setup of this unit for
multiple listening positions. For details, see
“Advanced automatic setup” (page 33). In
the basic automatic setup, leave this setting
to the default.
Wiring
(Speaker wiring) This unit checks and adjusts which speakers
are connected and the polarity of each
speaker.
Information
Setup Menu
Start
NOTICE
Loud test tones are
output.
Please keep quiet
or leave the room.
Start:ENTER