ZyXEL Communications P-2304R-P1 Series - Manual (Page 200)

Chapter 19 Logs
P-2304R-P1 Series User’s Guide
200
19.3 Log Message Descriptions
The following tables provide descriptions of example log messages.
Table 90 System Error Logs
LOG MESSAGE DESCRIPTION
WAN connection is down. The WAN connection is down. You cannot access the network
through this interface.
%s exceeds the max.
number of session per
host! This attempt to create a NAT session exceeds the maximum
number of NAT session table entries allowed to be created per
host.
Table 91 System Maintenance Logs
LOG MESSAGE DESCRIPTION
Time calibration is
successful The device has adjusted its time based on information from
the time server.
Time calibration failed The device failed to get information from the time server.
WAN interface gets IP: %s The WAN interface got a new IP address from the DHCP or
PPPoE server.
DHCP client gets %s A DHCP client got a new IP address from the DHCP server.
DHCP client IP expired A DHCP client's IP address has expired.
DHCP server assigns %s The DHCP server assigned an IP address to a client.
Successful WEB login Someone has logged on to the device's web configurator
interface.
WEB login failed Someone has failed to log on to the device's web configurator
interface.
TELNET Login Successfully Someone has logged on to the router via telnet.
TELNET Login Fail Someone has failed to log on to the router via telnet.
Successful FTP login Someone has logged on to the device via ftp.
FTP login failed Someone has failed to log on to the device via ftp.
NAT Session Table is Full! The maximum number of NAT session table entries has been
exceeded and the table is full.
Time initialized by Daytime
Server The device got the time and date from the Daytime server.
Time initialized by Time
server The device got the time and date from the time server.
Time initialized by NTP
server The device got the time and date from the NTP server.
Connect to Daytime server
fail The device was not able to connect to the Daytime server.
Connect to Time server fail The device was not able to connect to the Time server.
Connect to NTP server fail The device was not able to connect to the NTP server.
Too large ICMP packet has
been dropped The device dropped an ICMP packet that was too large.
Configuration Change: PC =
0x%x, Task ID = 0x%x The device is saving configuration changes.