Xerox 701P38969 - Manual (Page 24)

DOCUSP 3.x
20 XEROX DOCUMENT SERVICES PLATFORM SERIES
GETTING READY FOR THE DOCUSP INSTALLATION
W-8: SNMP Gateway installation worksheet
If the customer is planning on using the SNMP Gateway, fill out
this worksheet.
Data Elements Customer Value
Enabled YES NO
Printer ID (OID)
(See the Printer OID table)
Trap Client Lifetime
Trap Client Interval
Trap Polling Time
Packet Wait Time
10
(not to be changed)
Number of Trap Parameters 6
Read Community String
Write Community String
Trap Community String
Domain
UDP
IP Address or Port Number
Printer Alert
ON OFF
Cold Start ON OFF
Warm Start ON OFF
Link Up ON OFF
Link Down ON OFF
Authentication Failure ON OFF
Trap SNMP Version SNMPV1c
W-8 Data elements
Enabled: The System Administrator can enable or disable the
SNMP gateway as desired.
Printer ID (OID): Select the appropriate identification string
based on the model of the printer being installed from the table
below. This string must be entered exactly as there is no
validation of the string in case of an error.
Trap client lifetime: The Trap Client Lifetime determines how
long an active trap will live. Enter a value in seconds, such as
300 seconds.
NOTE: SNMP keeps a list of traps that are currently active.
Active traps that exist longer than the Trap Client Lifetime value
will be removed from the active list.
Trap client interval: The Trap Client Interval determines when
SNMP will check for trap expiration. For example, if the value is
60, every 60 seconds SNMP will check to remove any traps (as
appropriate) from the active list. Enter a value in seconds.