How to use the built-in timer, Timer play, E-52 – Yamaha GX-70 User Manual
Page 64: Current time (timer on/off mode), Source selecting mode (tape, tuner, cd), On time/time setting mode, Off time/time setting mode
E-52
1
PLAYBACK
2
REC/PLAYBACK
EJECT
OPEN/CLOSE
DISC CHANGE
Active Servo
Technology
1
2
3
DISC
PROGRAM
USER
VOLUME
DOWN
UP
MEMORY
DOWN
UP
REC/PAUSE
MODE
HOUR
MIN
NORMAL
DUBBING
HIGH
MEMORY
TIME ADJ
DOLBY NR
AUTO/MAN’L
TIMER
TIMER REC
MUSIC
POWER
PHONES
PRESET/TUNING/BAND
A/B/C/D/E
RANDOM
REPEAT
EDIT
DISPLAY
CD
INPUT
INPUT
TAPE 1/2
START
MODE
FREQ PS/PTY/RT/CT
PTY SEEK
EJECT
MINI COMPONENT SYSTEM
GX–70
HOW TO USE THE BUILT-IN TIMER
Timer play
By using the built-in timer, you can set the time when the unit
turns on and a source begins playing automatically, and the
time when the unit turns off automatically.
1
Prepare the source to be played.
For tuner:
Tune in to the station you will listen to.
For tape deck:
Load a tape into the cassette compartment.
(If tapes are loaded in both the compartments, tape 1
takes priority of tape 2, and is played back by the timer
play.)
For CD player:
Load a disc on the disc table. If more than one disc are
loaded on the disc table, select the disc by using the
DISC selector buttons or the DISC SKIP button.
2
Press the DISPLAY button.
Whenever the DISPLAY button is pressed, the display
mode changes as follows.
At each mode, make a setting for the timer play, referring
to the setting procedure described below.
➀
Current time (TIMER on/off mode)
➁
Source selecting mode (TAPE, TUNER, CD)
➂
ON TIME/Time setting mode
➃
OFF TIME/Time setting mode
➄
Normal display mode
* The display mode will be changed to the next mode
after about 8 seconds elapse automatically. If the mode
is changed before the setting is completed, call the
mode again by pressing the DISPLAY button once or
more.
Setting procedure:
➀
At the display of current time
Check to be sure that the current time is correct, and
press the TIMER button so that “TIMER” lights up on
the display.
➁
At source selecting mode
Select the source (TAPE, TUNER or CD) to be played
by pressing the corresponding input selector button.
* If “TUNER” is selected, soon it is changed to the
frequency display mode. In this mode, you can
select the station to listen to with the timer play by
using the PRESET/TUNING/BAND selector button,
A/B/C/D/E button and
/
buttons.
→
→→
→
→
1
1
2
2
3
3
4
4
5
5
TIME
A
DISC SKIP
PROG
B
TAPE
C
EDIT
D
+
I0
E
OPEN/CLOSE
RANDOM
REPEAT
MODE
6
6
7
7
8
8
9
0
CD
PRESET
TUNER
TAPE
STOP
STOP
PLAY/PAUSE
PLAY
PLAY
REC/PAUSE
TAPE 1/2
LEVEL
MUSIC
TEST
FLAT
CENTER/REAR
/DELAY
PROGRAM
USER
POWER
INPUT
SLEEP
VOLUME
2-
➀
2
2-
➁
2-
➁
2-
➁