Zenoah EBZ3000RH - Manual (Page 14)

GB-14
EBZ3000RH
9. Maintenance
10. Storage
BEFORE STORING THE BLOWER:
1. Drain a fuel tank and push the primer bulb until it be-
comes empty of fuel.
2. Remove the spark plug and drop a spoonful of 2-cycle
oil into the cylider. Crank the engine several times and
install the spark plug.
3. Store unit in a dry, dust free place, out of the reach of
children.
11. Disposal
When you dispose of the machine, do not disassemble
the machine.
When disposing your machine, fuel or oil for the machine,
be sure to allow your local regulations.
(1)Net
AIR INLET NET
IMPORTANT
• Blowing air is taken in from the air inlet net. When air
flow has dropped down during operation, stop the
engine and inspect the air inlet net for blocking by
obstacles.
• Note that failure to remove any such obstacles may
result in the engine becoming overheated and dam-
aged.
WARNING
Never use the blower without the net of the blower.
Before each use, check that the net is attached in
place and is free from any damage.
HARNESS
• If the harness is damaged it may break during use,
thus causing the product to fall and resulting in per-
sonal injury. Follow the instructions below to replace
the harness with new one.
1. Hook the upper part of the harness at the notch on
the top of the frame and pass it through the buckle as
shown in the figure, then secure it firmly.
2. Put the hook at the lower part of the harness in the
installing location at the bottom of the frame.
(1)
(2)
(3)
(4)
(1) Buckle (2) Frame
(3) Hook (4) D-ring