beautypg.com

Operation – Zenoah EBZ3000RH User Manual

Page 11

background image

GB-11

G

B

EBZ3000RH

exhaust port.

Never touch the muffler, spark plug, other metallic

parts of the engine or engine cover while the en-
gine is in operation or immediately after shutting
down the engine. These metallic parts and engine
cover reach high temperatures during operation
and doing so could result in serious burns.

6. Once the engine is running, gradually open the choke

if it was set closed, and let the engine run at idle speed
for a minute to warm it up.

NOTE

When the engine fails to start after several attempts due to
overchoking, open the choke and repeat pulling the rope.

ADJUSTING IDLE SPEED
• The idling speed is set for 3000 rpm at the factory. If it

is necessary to adjust the idle speed, use the adjust-
ment screw on the top side of carburetor.

(1)

STOPPING ENGINE
• Move the throttle lever to the idling position and set

the ignition switch to the stop position.

(1)

NOTE

If the engine won’t stop when setting the ignition switch

to the stop position, close the choke lever and stop
the engine.

In this case, please repair the machine at your nealest

servicing dealer.

STARTING ENGINE

IMPORTANT

Avoid operating the blower with the flexible tube

and swivel joint disconnected. That will reduce the
cooling air and the engine could be damaged by
overheating.

1. Push the primer bulb until fuel flows out in the clear

tube.

2. When the engine is cool, close the choke.

3. Set the ignition switch to the start position.

(1)

(2)

(3)

4. Set the throttle lever in idling position.

5. To start, hold the top of the blower firmly with your left

hand. Pull the starter knob slowly until you feel it en-
gage and then give it a vigorous strong pull.

IMPORTANT

Avoid pulling the starter rope out to its full extent

and allowing the starter rope to snap back. This
will prevent premature damage to the starter.

Do not let a person stand near the blower or the

8. Operation

(1)Choke Lever
(2)CLOSE
(3)OPEN

(1)Idling
Adjustment Screw

(1)Ignition Switch

(1)Full Throttle
(2)Idling
(3)Ignition Switch

(1)Choke Lever
(2)CLOSE
(3)OPEN

(1)Primer Bulb