Yamaha WA66540 - Manual (Page 14)

Front & Rear Panels
MG32/14FX, MG24/14FX 14
■ GROUP Section
This section adjusts the level and controls the flow of the signals
from the four GROUP buses. While the signal from each GROUP
bus is always fed into the corresponding GROUP OUT jack (see
page 20), you are also free to use the TO ST and AFL switches to
selectively feed these groups into the ST and AFL buses.
1 PAN Control
If you are feeding the signal from the GROUP bus into the ST
bus (that is, if the corresponding TO ST switch ( 2 ) is on), this
knob controls how the signal is positioned on the ST L/R lines.
2 TO ST Switches
For each group: If the switch is on ( ), the mixer feeds the
signal from the GROUP bus into the ST bus, after first passing
the signal through the GROUP fader ( 4 ) and the PAN control
( 1 ).
3 AFL (After-Fader Listen) Switches
Feeds the corresponding GROUP OUT signal into the AFL
bus, so that this signal can be monitored at the PHONES jack.
4 Group Faders
Each fader adjusts the level of the signal that is fed to the corre-
sponding GROUP OUT jack.
■ SEND Section
This section adjusts the levels and controls the flow of the signals
from the six AUX buses and the two EFFECT buses. Each of these
signals flows to the corresponding SEND output jack (to
AUX1–AUX6, EFF1, and EFF2, respectively).
1 AUX Controls (AUX1 to AUX6)
Each knob adjusts the level of the signal from the indicated
AUX bus into the corresponding AUX SEND jack.
2 Effect Controls (EFF1, EFF2)
Each knob adjusts the level of the signal from the indicated
EFFECT bus into the corresponding EFFECT SEND jack and
also into the corresponding internal digital effect.
For each channel, you use the channel’s AUX5/6
switch (see page 11) to select between feed into the
AUX5 and 6 buses or feed into the EFFECT 1 and 2
buses. If the switch is on (
), the signal goes to
the AUX5 and AUX6 SEND jacks. If the switch is off
(
), the signal goes to the EFF1 and EFF2 SEND
jacks.
3 AFL (After-Fader Listen) Switches
For each AUX and EFFECT bus: Use this switch to feed the
corresponding AUX SEND or EFF SEND signal into the AFL
bus. Feeds the corresponding AUX SEND or EFF SEND signal
into the AFL bus, so that this signal can be monitored at the
PHONES jack.
If you set this switch on for EFF1 or EFF2, you can
use the PHONES jack to monitor the signal to the
corresponding internal digital effect.
1
2
3
4
3
1
2
N O T E
N O T E