Zanussi ZMU17MXL - Manual (Page 15)

ZMU17MXL English
17
•
The earthed socket must be easily accessible. Ideally
it should be located underneath the cabinet to which
the microwave is to be attached. The mains cable
must not touch the back of the appliance.
If the socket is not accessible, a device must be fitted
when the appliance is installed allowing all pins of the
plug to be disconnected from the mains with a
contact gap of at least 3 mm. Suitable separating
devices would be excess current switches, safety
fuses and magnetic contactors.
The attachment kit consists of:
(A) 4 fixing screws
(ø 5 x 35 mm for a cabinet floor thickness of 10 -
23 mm)
(B) 4 washers (ø ca.25 mm)
(C) 4 washers (ø ca.11 mm)
(D) Drilling template
Tools required
• Pencil
•
Ruler/measuring tape
•
Adhesive tape
• Drill
•
Drill bit (ø 5.5 mm)
•
Phillips screwdriver
• Information on installing the microwave
Important :
The length of the screws is designed for use where
the thickness of the floor of the cabinet is 10 - 23
mm. Where the thickness is greater or less than this,
the fixing will not be sufficiently solid.
Building In Instructions