Yamaha T50D - Manual (Page 32)

Operation
27
● Check fuel line connections to be sure they
are tight (if equipped Yamaha fuel tank or
boat tank).
● Be sure the fuel tank is positioned on a se-
cure, flat surface, and that the fuel line is
not twisted or flattened, or likely to contact
sharp objects (if equipped Yamaha fuel
tank or boat tank).
EMU27130
Controls
● Check throttle, shift, and steering for prop-
er operation before starting the engine.
● The controls should work smoothly, with-
out binding or unusual free play.
● Look for loose or damaged connections.
● Check operation of the starter and stop
switches when the outboard motor is in the
water.
EMU27150
Engine
● Check the engine and engine mounting.
● Look for loose or damaged fasteners.
● Check the propeller for damage.
● Check that the battery is in good condition
and the battery connections are secure.
EMU27163
Checking the engine oil level
1. Put the outboard motor in an upright po-
sition (not tilted).
2. Remove oil dipstick and wipe it clean.
3. Completely insert the dipstick and re-
move it again.
4. Check the oil level using the dipstick to
be sure the level falls between the upper
and lower marks. Fill with oil if it is below
the lower mark, or drain to the specified
level if it is above the upper mark.
NOTE:
Be sure to completely insert the dipstick into
the dipstick guide.
EMU27433
Filling fuel
WARNING
EWM00060
Gasoline and its vapors are highly flam-
mable and explosive. Keep away from
sparks, cigarettes, flames, or other
sources of ignition.
1. Remove the fuel tank cap.
2. Carefully fill the fuel tank.
3. Securely close the cap after filling the
1. Oil dipstick
1. Lower level mark
2. Oil dipstick
3. Upper level mark
1
ZMU05089
1 3 2
ZMU05091